Acar, Aslıİnan, ÖzgürHalkacı, Selçuk2020-03-262020-03-2620071552-49731552-4981https://dx.doi.org/10.1002/jbm.b.30730https://hdl.handle.net/20.500.12395/21360The aim of this study was to determine the effect of airborne-particle abrasion (APA), sodium hydroxide anodization (SHA), and electrical discharge machining (EDM) on cast titanium surfaces and titanium-porcelain adhesion. Ninety titanium specimens were cast with pure titanium and the alpha-case layer was removed. Specimens were randomly divided into three groups. Ten specimens from each group were subjected to APA. SHA was applied to the second subgroups, and the remaining specimens were subjected to the EDM. For the control group, 10 specimens were cast using NiCr alloy and subjected to only APA. Surfaces were examined by using scanning electron microscope and a surface profilometer. Three titanium porcelains were fused on the titanium surfaces, whereas NiCr specimens were covered with conventional porcelain. Titanium-porcelain adhesion was characterized by a 3-point bending test. Statistical analysis showed that the porcelain-metal bond strength of the control group was higher than that of the titanium-porcelain system (p < 0.05). There were no significant differences between the bond strengths of titanium groups (p > 0.05), except the bond strengths of Noritake Super Porcelain TI-22 groups on which APA and SHA were applied (p < 0.05). SHA and EDM as surface treatment did not improve titanium-porcelain adhesion when compared to APA. (c) 2006 Wiley Periodicals, Inc.en10.1002/jbm.b.30730info:eu-repo/semantics/closedAccesstitaniumtitanium porcelainairborne-particle abrasionsodium hydroxide anodizationelectrical discharge machiningArticle82B126727417183560Q2WOS:000247612600034Q2