Duzyol, S.Ozkan, A.2020-03-262020-03-2620140892-6875https://dx.doi.org/10.1016/j.mineng.2014.05.015https://hdl.handle.net/20.500.12395/30764The influences of contact angle, surface tension and zeta potential on oil agglomeration recovery of celestite mineral have been investigated in the present work. Therefore, celestite mineral in methanol-water suspension was agglomerated by the use of oil (kerosene) in the presence of sodium oleate as a surfactant. The zeta potential values of celestite surfaces were measured depending on pH and sodium oleate concentration. The zeta potential values of celestite surfaces became negative even more owing to the sodium oleate adsorption. However, this phenomenon did not affect the oil agglomeration recovery at all. It was found that both increasing contact angle and surface tension raised the oil agglomeration recovery of celestite mineral. Eventually, the agglomeration degree of celestite mineral in the suspension was not lower than a particular surface tension value corresponding to the critical solution surface tension for oil agglomeration (gamma(c-a)). The gamma(c-a) values were slightly greater than the critical surface tension of wetting (gamma(c)) values. (C) 2014 Elsevier Ltd. All rights reserved.en10.1016/j.mineng.2014.05.015info:eu-repo/semantics/closedAccessCelestiteOil agglomerationContact angleSurface tensionZeta potentialArticle657478Q1WOS:000341744100010Q1