Yazar "Demir N." seçeneğine göre listele

Listeleniyor 1 - 2 / 2
  • Küçük Resim Yok
    Öğe
    A different wax sculpture technique for implant-retained auricular prosthesis
    (Dental Investigations Society, 2015) Demir N.; Cevik P.; Okutan Y.; Nilgun Ozturk A.; Colpan B.
    Replacement of missing ears is a challenging task in which extensive array of materials and techniques have been employed. This article describes a different and simplified procedure for fabricating auricular prostheses very similar to the intact left ear of the patient. A 65-year-old male patient was referred to the Department of Prosthodontics with the loss of the right ear. In this case, the impression was made using hydrocolloid material (alginate) from the both defected and the opposite side. After hardening of the stone casts, a custom-made transparent splint plate was designed for the left auricular side. The splint was reversed and a cast model of the right auricular side was obtained as pouring the dental stone into transparent orthodontic splint. After getting the impression from cast model, conventional wax pattern and try on process was done. Finally, silicone elastomer was polymerized and the retention of the prosthesis acquired with the magnetic attachments. The technique described is economical, conventional, and time-saving. Furthermore, the prosthesis imitates the patient's intact auricular tissue. © 2015 European Journal of Dentistry.
  • Küçük Resim Yok
    Öğe
    Evaluation of the marginal fit of full ceramic crowns by the microcomputed tomography (micro-CT) technique
    (Dental Investigations Society, 2014) Demir N.; Ozturk A.N.; Malkoc M.A.
    Objective: To evaluate the marginal gap (MG) and absolute marginal discrepancy (MD) of full ceramic crowns with two finish line designs, shoulder and chamfer, using microcomputed tomography (micro-CT) before and after cementation. Materials and Methods: Sixty extracted human maxillary premolar teeth were divided into two groups based on the finish line design: Group I: 90° shoulder and Group II: 135° chamfer. The specimens were further grouped based on the type of full ceramic crown they received: Group A: Feldspathic Cerec inLab ceramic system, Group B: Cerec inLab aluminum oxide ceramic system and Group C: Lithium disilicate press ceramic system. Before cementation, five crowns from each group were scanned using micro-CT in two sections, sagittal and coronal, to determine the MG and MD values for four regions of the crown (sagittal buccal, sagittal lingual, coronal mesial and coronal distal). After cementation and thermal cycling, the scanning was repeated. Measurements were obtained from 10 points for each region, 80 points totally, to evaluate the MG and MD values. Files were processed using NRecon and CTAn software. Results were statistically analyzed using one- and two-way ANOVA and Tukey HSD tests (P = 0.05). Results: Full ceramic systems showed clinically acceptable marginal adaptation values. The Feldspathic Cerec inLab ceramic system generally presented the lowest variance, except in the MG values of the coronal mesial region. The MG and MD values of all ceramics increased significantly after cementation, except in the shoulder preparation design (sagittal buccal region) for MG and in the chamfer preparation design (sagittal lingual region) for MD values. Conclusions: Full-ceramic crowns showed clinically acceptable marginal adaptation values. The Feldspathic Cerec inLab ceramic system (Vitablocs Mark II) generally presented the lowest variance when compared with the other ceramics, except for the MG values on the mesial surface of the coronal section. © 2014 Dental Investigations Society.