The Effect of Milling Time and Ball Diameter on Mechanical Alloying [Öğütme Zamani Ve Bilya Çapinin Mekanik Alaşimlamaya Etkisi]
Küçük Resim Yok
Tarih
1999
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
The effect of milling time and ball diameter on mechanical alloying of Fe-Cr-Al powders in high energy ball mill have been analysed. Investigated of mechanically alloyed powders were carried out by SEM with EDAX and the most suitable ball diameter and alloying time were determined. It was found that the most suitable ball diameter was 1/4? and 48 hours milling time was the best for these powders.
Açıklama
Ulusal Toz Metalurjisi Konferansi: Second National Powder Metallurgy Conference -- 15 September 1999 through 17 September 1999 -- Ankara -- 62638
Anahtar Kelimeler
Fe-Cr-Al alloys, Mechanical alloying, Milling balls, Milling time
Kaynak
Ulusal Toz Metalurjisi Konferansi: National Powder Metallurgy Conference
WoS Q Değeri
Scopus Q Değeri
N/A
Cilt
Sayı
Künye
Kilinç, Y., Türker, M., Saritaş, S., (1999). The Effect of Milling Time and Ball Diameter on Mechanical Alloying [öğütme Zamani Ve Bilya Çapinin Mekanik Alaşimlamaya Etkisi]. Ulusal Toz Metalurjisi Konferansi: National Powder Metallurgy Conference, 417-424.
