Sliding mode control of a two-link robot manipulator using adams matlab software

Küçük Resim Yok

Tarih

2018

Dergi Başlığı

Dergi ISSN

Cilt Başlığı

Yayıncı

Institute of Electrical and Electronics Engineers Inc.

Erişim Hakkı

info:eu-repo/semantics/closedAccess

Özet

This paper presents the design of a sliding mode controller (SMC) for trajectory tracking problem for a two-link planar robot manipulator. A virtual prototype of the manipulator has been built by using Adams software. Also, the controller works is achieved in Matlab/Simulink software. The system is simulated in both Matlab and Adams software together which is called co-simulation. The manipulator system has two inputs (torques of actuators) and four outputs (angle of 1st joint, angle of 2nd joint and x-y components of end effector position). The sliding mode controller (SMC) is designed with the constant variation reaching law. The simulation results show that the sliding mode controller (SMC) can successfully achieve trajectory tracking of a two-link planar robot manipulator according to the desired trajectory. © 2018 IEEE.

Açıklama

6th International Conference on Control Engineering and Information Technology, CEIT 2018 -- 25 October 2018 through 27 October 2018 -- 149175

Anahtar Kelimeler

Adams, Matlab, Robot manipulators, Sliding mode control, Trajectory tracking, Two-link robot

Kaynak

2018 6th International Conference on Control Engineering and Information Technology, CEIT 2018

WoS Q Değeri

Scopus Q Değeri

N/A

Cilt

Sayı

Künye