Effect of finishing methods on surface roughness and color stability in all-ceramic systems
Küçük Resim Yok
Tarih
2011
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
ELSEVIER SCIENCE BV
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
The objectives of the study were to evaluate the effect of the finishing methods on the surface roughness, and to investigate changes in CIE L*a*b* color coordinates of all-ceramic systems after different finishing methods and accelerated aging. Sixty specimens were prepared, 20 specimens each for Vitadur-N, IPS Empress II, and Cerec Vita Block Mark II. The surface roughness (Ra) following treatment with the different finishing methods was measured using a profilometer. Surface examinations in all groups were made by using a scanning electronic microscope. CIE L*a*b* values of the specimens were determined. After all specimens were subjected to accelerated aging, color measurements were repeated, and the total color differences (Delta E) were calculated. Data were analyzed statistically. Significant differences in surface roughness among all-ceramics were found (P < 0.05). No significant differences were found between the surface roughness of the glazed and polished all-ceramics (P > 0.05). After accelerated aging, all groups had acceptable color changes (Delta E < 2). (c) 2011 Elsevier B.V. All rights reserved.
Açıklama
Anahtar Kelimeler
All-ceramic systems, Surface roughness, Polishing, Glazing, Color
Kaynak
JOURNAL OF NON-CRYSTALLINE SOLIDS
WoS Q Değeri
Q1
Scopus Q Değeri
Q2
Cilt
357
Sayı
06.07.2020
