Neural Model for the Leaching of Celestite in Sodium Carbonate Solution

Yükleniyor...
Küçük Resim

Tarih

2010

Dergi Başlığı

Dergi ISSN

Cilt Başlığı

Yayıncı

ELSEVIER SCIENCE SA

Erişim Hakkı

info:eu-repo/semantics/openAccess

Özet

A neural model for computing the conversion kinetics of SrSO(4) to SrCO(3) was investigated in sodium carbonate solution, based on the multilayered perceptrons was presented. For this purpose the artificial neural network (ANN) method was used. The effects of stirring speed, temperature, mole ratio Na(2)CO(3):SrSO(4) and particle size of the celestite on leaching kinetics were studied. The surface transformation of celestite to strontium carbonate in aqueous carbonate solutions was also supported by FT-IR spectroscopy. The conversion rate of celestite increases systematically with increasing temperature (up to 70 degrees C). Furthermore, the feasibility of replacing the SO(4)(2-) ions with CO(3)(2-) ions in the structure of the leached solid was also investigated by FT-IR. FT-IR results showed that the replacement of SO(4)(2-) ions in celestite by CO(3)(2-) ions in leaching conditions was nearly completed at 60 degrees C with a mole ratio Na(2)CO(3):SrSO(4) = 4:1, solid to liquid =5:500, -212+106 mu m particle size, and 400 rpm stirring rate for an interval of 240 min. The first (up to 90 min) conversion result obtained was trained with an extended delta-bar-delta algorithm (EDBD), which is in the multilayered perceptions and is a neural model structure. Results of other conversion times (90-240 min) results were predicted. Results predicted by the neural model were in very good agreement with the experimental results.

Açıklama

Anahtar Kelimeler

Celestite, Strontium Carbonate, Artificial Neural Network (ANN), Extended Delta-Bar-Delta (EDBD)

Kaynak

Chemical Engineering Journal

WoS Q Değeri

Q1

Scopus Q Değeri

Q1

Cilt

165

Sayı

2

Künye

Bingöl, D., Aydoğan, S., Gültekin, S. S., (2010). Neural Model for the Leaching of Celestite in Sodium Carbonate Solution. Chemical Engineering Journal, 165(2), 617-624. DOI: 10.1016/j.cej.2010.10.007