Investigation of the effect of rake angle and approaching angle on main cutting force and tool tip temperature

Basit Öğe Kaydı
dc.contributor.authorSaglam, H
dc.contributor.authorUnsacar, F
dc.contributor.authorYaldiz, S
dc.date.accessioned2020-03-26T17:03:47Z
dc.date.available2020-03-26T17:03:47Z
dc.date.issued2006
dc.departmentSelçuk Üniversitesien_US
dc.description.abstractThis paper deals with the comparison of measured and calculated results of cutting force components and temperature variation generated on the tool tip in turning for different cutting parameters and different tools having various tool geometries while machining AISI 1040 steel hardened at HRc 40. The geometric variables (approaching angle and rake angle) of the tool were changed using selected cutting parameters; thus, the cutting force components and temperature variations on tool face (in secondary shear zone) were determined. The selected cutting variables and the tools in different geometries were tested practically under workshop conditions. in this way, the essential information about the validity of selected values was obtained. During the tests, the depth of cut and cutting speed were kept constant and each test was conducted with a sharp uncoated tool insert. For making a comparison, the main cutting force/tangential force component for different cutting parameters and tool geometries were calculated by Kienzle approach and the temperature values were calculated based on orthogonal cutting mechanism. Finally, the effects of cutting parameters and tool geometry on cutting forces and tool tip temperature were analysed. The average deviation between measured and calculated force results were found as 0.37%. The cutting force signals and temperature values provided extensive data to analyse the orthogonal cutting process. (c) 2005 Elsevier Ltd. All rights reserved.en_US
dc.identifier.doi10.1016/j.ijmachtools.2005.05.002en_US
dc.identifier.endpage141en_US
dc.identifier.issn0890-6955en_US
dc.identifier.issn1879-2170en_US
dc.identifier.issue2en_US
dc.identifier.scopusqualityQ1en_US
dc.identifier.startpage132en_US
dc.identifier.urihttps://dx.doi.org/10.1016/j.ijmachtools.2005.05.002
dc.identifier.urihttps://hdl.handle.net/20.500.12395/20556
dc.identifier.volume46en_US
dc.identifier.wosWOS:000234474000006en_US
dc.identifier.wosqualityQ1en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.indekslendigikaynakScopusen_US
dc.language.isoenen_US
dc.publisherELSEVIER SCI LTDen_US
dc.relation.ispartofINTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTUREen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.selcuk20240510_oaigen_US
dc.subjectcutting forcesen_US
dc.subjecttool tip temperatureen_US
dc.subjectapproaching angleen_US
dc.subjectrake angleen_US
dc.titleInvestigation of the effect of rake angle and approaching angle on main cutting force and tool tip temperatureen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu