Optimization of tool geometry parameters for turning operations based on the response surface methodology

Basit Öğe Kaydı
dc.contributor.authorNeseli, Suleyman
dc.contributor.authorYaldiz, Suleyman
dc.contributor.authorTurkes, Erol
dc.date.accessioned2020-03-26T18:15:32Z
dc.date.available2020-03-26T18:15:32Z
dc.date.issued2011
dc.departmentSelçuk Üniversitesien_US
dc.description.abstractThis investigation focuses on the influence of tool geometry on the surface finish obtained in turning of AISI 1040 steel. In order to find out the effect of tool geometry parameters on the surface roughness during turning, response surface methodology (RSM) was used and a prediction model was developed related to average surface roughness (Ra) using experimental data. The results indicated that the tool nose radius was the dominant factor on the surface roughness. In addition, a good agreement between the predicted and measured surface roughness was observed. Therefore, the developed model can be effectively used to predict the surface roughness on the machining of AISI 1040 steel with in 95% confidence intervals ranges of parameters studied. (C) 2010 Elsevier Ltd. All rights reserved.en_US
dc.identifier.doi10.1016/j.measurement.2010.11.018en_US
dc.identifier.endpage587en_US
dc.identifier.issn0263-2241en_US
dc.identifier.issn1873-412Xen_US
dc.identifier.issue3en_US
dc.identifier.scopusqualityQ1en_US
dc.identifier.startpage580en_US
dc.identifier.urihttps://dx.doi.org/10.1016/j.measurement.2010.11.018
dc.identifier.urihttps://hdl.handle.net/20.500.12395/26701
dc.identifier.volume44en_US
dc.identifier.wosWOS:000287275200010en_US
dc.identifier.wosqualityQ2en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.indekslendigikaynakScopusen_US
dc.language.isoenen_US
dc.publisherELSEVIER SCI LTDen_US
dc.relation.ispartofMEASUREMENTen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.selcuk20240510_oaigen_US
dc.subjectSurface roughnessen_US
dc.subjectResponse surface methodologyen_US
dc.subjectOptimizationen_US
dc.titleOptimization of tool geometry parameters for turning operations based on the response surface methodologyen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu