The effects of stacking sequence on drilling machinability of filament wound hybrid composite pipes: Part-1 mechanical characterization and drilling tests

Basit Öğe Kaydı
dc.contributor.authorGemi L.
dc.contributor.authorKöklü U.
dc.contributor.authorYazman
dc.contributor.authorMorkavuk S.
dc.date.accessioned2020-03-26T20:20:58Z
dc.date.available2020-03-26T20:20:58Z
dc.date.issued2020
dc.departmentSelçuk Üniversitesien_US
dc.description.abstractIn the first part of this two-part comprehensive study, mechanical properties and machinability characteristic of filament wound hybrid composite pipes with various stacking sequences of glass and carbon fibers (Glass-Carbon-Glass (GCG), Carbon-Glass-Glass (CGG), and Glass-Glass-Carbon (GGC)) were investigated experimentally. In order to determine the mechanical properties of the pipes, hardness test (Shore D), ring tensile test (ASTM D2290), and burst test (ASTM D1599) were carried out. Machinability tests were performed at various feed rates (50, 150, 250 and 350 mm/min) and spindle speeds (796, 1592, 2388 and 3184 rpm) using with and without a back-up. The results showed that stacking of the carbon layer between two glass layers (GCG) presented better performance in terms of mechanical properties and machinability characteristic. The maximum ring tensile stress of GCG specimen is 27% and 19% higher than those of GGC and CGG specimens, respectively. On the other hand, the lowest thrust forces measured during the drilling of GCG specimen while the GGC represented highest values. In addition, the use of back-up led to an increase in thrust force. The highest increase was observed in GGC sample. In GGC sample, a change in a spindle speed increased thrust force by 18–35%, while a change in feed rate increased thrust force by 20–30%. © 2020 Elsevier Ltden_US
dc.identifier.doi10.1016/j.compositesb.2020.107787en_US
dc.identifier.issn1359-8368en_US
dc.identifier.scopusqualityQ1en_US
dc.identifier.urihttps://dx.doi.org/10.1016/j.compositesb.2020.107787
dc.identifier.urihttps://hdl.handle.net/20.500.12395/38709
dc.identifier.volume186en_US
dc.identifier.wosWOS:000518706900003en_US
dc.identifier.wosqualityQ1en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.indekslendigikaynakScopusen_US
dc.language.isoenen_US
dc.publisherElsevier Ltden_US
dc.relation.ispartofComposites Part B: Engineeringen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.selcuk20240510_oaigen_US
dc.subjectComposite hybrid pipeen_US
dc.subjectComposite pipeen_US
dc.subjectDrillingen_US
dc.subjectFilament windingen_US
dc.subjectMachinabilityen_US
dc.subjectStacking sequenceen_US
dc.titleThe effects of stacking sequence on drilling machinability of filament wound hybrid composite pipes: Part-1 mechanical characterization and drilling testsen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

Scopus İndeksli Yayınlar Koleksiyonu
WoS İndeksli Yayınlar Koleksiyonu