The Effect of Additional Enamel Etching and a Flowable Composite to the Interfacial Integrity of Class Ii Adhesive Composite Restorations

Basit Öğe Kaydı
dc.contributor.authorBelli, Sema
dc.contributor.authorInokoshi, S
dc.contributor.authorÖzer, Faruk
dc.contributor.authorPereira, PNR
dc.contributor.authorOgata, M
dc.contributor.authorTagami, J
dc.date.accessioned2020-03-26T16:37:28Z
dc.date.available2020-03-26T16:37:28Z
dc.date.issued2001
dc.departmentSelçuk Üniversitesien_US
dc.description.abstractThis in vitro study evaluated the interfacial integrity of Class II resin composite restorations. The influence of a flowable composite and additional enamel etching was also evaluated. Deep, saucer-shaped Class LI cavities were prepared in the mesial and distal proximal surfaces of 25 extracted human molars and assigned to five treatment groups. The gingival margins were extended to approximately 1 mm above the CEJ in 40 cavities and below the CEJ in 10 cavities. The prepared cavities were then restored with a self-etching primer system (Clearfil Liner Bond LT) and a hybrid resin composite (Clearfil AP-X), with and without a flowable composite (Protect Liner Fl and additional enamel etching with 37% phosphoric acid gel (K-etchant). After finishing, polishing and thermocycling (4 and 60 degreesC, x300), the samples were longitudinally sectioned through the restorations and resin-tooth interfaces were observed directly under a laser scanning microscope. Statistical analysis indicated that the use of a flowable composite produced significantly more (p=0.04) gap-free resin-dentin interfaces than teeth restored without the flowable composite. However, both flowable composite and enamel etching could not prevent gap formation at enamel-resin interfaces and crack formation on enamel walls. en_US
dc.identifier.citationBelli, S., Inokoshi, S., Özer, F., Pereira, P. N. R., Ogata, M., Tagami, J., (2001). The Effect of Additional Enamel Etching and a Flowable Composite to the Interfacial Integrity of Class Ii Adhesive Composite Restorations. Operative Dentistry, 26(1), 70-75.
dc.identifier.endpage75en_US
dc.identifier.issn0361-7734en_US
dc.identifier.issn1559-2863en_US
dc.identifier.issue1en_US
dc.identifier.pmid11203780en_US
dc.identifier.scopusqualityQ1en_US
dc.identifier.startpage70en_US
dc.identifier.urihttps://hdl.handle.net/20.500.12395/17625
dc.identifier.volume26en_US
dc.identifier.wosWOS:000166377100012en_US
dc.identifier.wosqualityQ2en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.indekslendigikaynakScopusen_US
dc.indekslendigikaynakPubMeden_US
dc.institutionauthorBelli, Sema
dc.institutionauthorÖzer, Faruk
dc.language.isoenen_US
dc.publisherOPERATIVE DENTISTRY INCen_US
dc.relation.ispartofOperative Dentistryen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.selcuk20240510_oaigen_US
dc.titleThe Effect of Additional Enamel Etching and a Flowable Composite to the Interfacial Integrity of Class Ii Adhesive Composite Restorationsen_US
dc.typeArticleen_US

Dosyalar

Orijinal paket
Listeleniyor 1 - 1 / 1
Küçük Resim
İsim:
belli2004.pdf
Boyut:
81.63 KB
Biçim:
Adobe Portable Document Format
Açıklama:
İndir

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Endodonti/Makale Koleksiyonu
PubMed İndeksli Yayın Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu